CHASSIS
3-107Toro GrandStand Service Manual
3
56. 2010 only: Loosely install the remaining three
carriage bolts, Belleville washers, and nuts (Fig.
0402).
Fig. 0402 DSCN-1237a
57. 2010 only: Tighten the four sets of fasteners.
58. Position the left hand lift plate over the grease block
with the bolt hole pattern aligned with the mating
pattern on the engine base (Fig. 0403).
Fig. 0403 DSCN-1245a
60. Tighten the four sets of fasteners.
61. Position the rear axle assembly behind the engine
base assembly (Fig. 0405).
Fig. 0405 DSCN-1378a
59. Loosely install four carriage bolts, Belleville washers,
nuts (Fig. 0404).
Fig. 0404 DSCN-1243a
To Next Page
Loading...
