Toro GrandStand Series - Page 129

CHASSIS
3-108 Toro GrandStand Service Manual
3
62. Using two people or a hoist, lift the rear end of the
carrier frame and tower assembly (Fig. 0406).
Fig. 0406 DSCN-1382a
63. Walk the carrier frame and tower assembly rear-
ward, over the engine and deck assembly (Fig.
0407).
Fig. 0407 DSCN-1385a
64. Loosely install the four sets of bolts, spacers and
nuts (two sets per side) that secure the axle and
wheel assembly to the carrier frame (Fig. 0408).
Fig. 0408 DSCN-1386a
Note: The bolts are installed downwards though the
carrier frame, then down through the wheel
motor mounts (Fig. 0409).
Fig. 0409 DSCN-1389a