CHASSIS
3-109Toro GrandStand Service Manual
3
65. Tighten all four sets of fasteners.
66. 2009 only: Install the spacer into the rear cross
shaft hub (Fig. 0410).
67. 2009 only: Install the bolt through the carrier frame,
then through the spacer and hub assembly (Fig.
0411).
Fig. 0410 DSCN-1603a
Fig. 0411 DSCN-1606a
68. 2009 only: Secure the assembly using a washer
and nut (Fig. 0412).
Fig. 0412 DSCN-1607a
69. 2009 only: Repeat steps 66 through 68 on the other
side of the unit.
70. 2010 only: Position the RH pivot shaft through the
carrier frame hub and rear cross shaft assembly
(Fig. 0413).
Note: 48” and 52” decks are set to a narrow stance.
Remove the wheels to install the pivot shafts.
Reinstall the wheels after installing the pivot
shafts.
Fig. 0413 DSCN-1392a
To Next Page
Loading...
