CHASSIS
3-110 Toro GrandStand Service Manual
3
71. 2010 only: Rotate the pivot shaft so the spiral pin
hole of the pivot shaft aligns with the spiral pin hole
of the rear cross shaft assembly, then secure the
assembly with the spiral pin (Fig. 0414).
72. 2010 only: Repeat steps 70 and 71 on the LH side
of the machine.
73. Connect the “Z” bend of the speed control cable to
the speed control handle assembly (Fig. 0416).
Fig. 0414 DSCN-1395a
Note: The spiral pin ends need to be ush to the lift
arm hub (Fig. 0415).
Fig. 0415 DSCN-1400a
Fig. 0416 DSCN-1015a
74. Secure the speed control cable to the speed control
handle assembly with the clip on the end of the
cable jacket (Fig. 0417).
Fig. 0417 DSCN-1482a
To Next Page
Loading...
