Toro GrandStand Series - Page 136

CHASSIS
3-115Toro GrandStand Service Manual
3
89. Position the opposite end of the lift rod over the stud
on the rear cross shaft assembly (Fig. 0433).
Fig. 0433 DSCN-0801a
Note: Ensure the ange bearing is still in place (Fig.
0434).
Fig. 0434 DSCN-0804a
90. Position the large washer over the rear cross shaft
stud (Fig. 0435).
Fig. 0435 DSCN-0807a
91. Secure the assembly using the “E” clip (Fig. 0436).
Fig. 0436 DSCN-0808a