CHASSIS
3-121Toro GrandStand Service Manual
3
109. 2010 only: Secure the extension spring assembly
and chain to the control tower using the bolt and
washer (Fig. 0456).
Fig. 0456 DSCN-0818a
110. 2010 only: Install the bolt until the gap between
the control tower mount and spring cap is 1-1/2”
(3.8mm) for 60” decks / 2” (50mm) 48” or 52”
decks (Fig. 0457).
Fig. 0457 DSCN-0820a
A. 1-1/2” (3.8cm) for 60” decks
2” (5cm) for 48” for 52” decks
A
111. 2010 only: Repeat steps 108 through 110 on the
other side of the machine.
112. Install the fuel tank. See “Fuel Tank Assembly
Installation” on page 3-29.
113. 2009 only: Secure the lower end of the lift bar to
the rear cross shaft assembly using a nut. Thread
the nut onto the bolt until there are 3 threads
protruding. Secure the position with the jam nut
(Fig. 0458).
Fig. 0458 DSCN-0274a
To Next Page
Loading...
