CHASSIS
3-123Toro GrandStand Service Manual
3
117. Secure the black ground cable to the negative
terminal on the battery using the bolt, washer and
nut (Fig. 0463).
Fig. 0463 DSCN-1499a
119. Verify the mower deck is properly adjusted. See
“Mower Deck Adjustments - Correcting the Mower
Quality of Cut” on page 7-50.
120. Bleed the hydraulic system. See “Bleeding the
Hydraulic System” on page 6-95.
118. Secure the battery to the battery tray using the
battery cover, hold down bolts and wing nuts (Fig.
0464).
Fig. 0464 DSCN-1504a
Carrier Frame Replacement
Carrier Frame Removal
1. 2009 only: Remove the lift assist cylinder. See “Lift
Assist Cylinder Removal (2009 only)” on page 3-40.
2. Place two boards under the deck and lower the deck
onto them (Fig. 0465).
Note: The boards need to be long enough to sup-
port the front and rear of the deck.
Fig. 0465 DSCN-0685a
3. 2009 only: Remove the nut securing the lift bar to
the rear cross shaft assembly (Fig. 0466).
Fig. 0466 DSCN-0795a
To Next Page
Loading...
