CHASSIS
3-125Toro GrandStand Service Manual
3
9. 2010 only: Remove the bolts and washers securing
the exten sion spring assemblies and chains to the
RH and LH sides of the control tower (Fig. 0471).
Fig. 0471 DSCN-0700a
10. Remove the “E” clips and washers securing the RH
and LH lift rod to the rear cross shaft assembly (Fig.
0472).
Fig. 0472 DSCN-0704a
11. 48” and 52” decks only: Remove the nuts from
the end of the lift rods and remove the RH and LH lift
rods (Fig. 0473).
Note: Leave the inside nuts in their location to
minimize deck leveling adjustments at the
end of this procedure.
Fig. 0473 DSCN-0707a
12. 60” decks only: Loosen the rear jam nuts securing
the LH and RH lift rods to the turn buckle, then
remove the RH and LH lift rods (Fig. 0474).
Note: Note the position of the jam nuts to minimize
deck leveling adjustments at the end of this
procedure.
Fig. 0474 DSCN-0710a
To Next Page
Loading...
