CHASSIS
3-126 Toro GrandStand Service Manual
3
13. 2009 only: Remove the bolts, spacers and washers
securing the cross shaft assembly to the carrier
frame (Fig. 0475).
14. 2010 only: Using a blunt punch, drive the spiral
pins that secure the LH and RH pivot shafts to the
rear cross shaft assembly (Fig. 0476).
Fig. 0476 DSCN-0712a
Fig. 0475 DSCN-1602a
15. 2010 only: Remove the LH and RH pivot shafts
from the rear cross shaft assembly and carrier frame
hub (Fig. 0477).
Note: 48” and 52” decks are set to a narrow stance.
Remove the wheels to remove the pivot
shafts. Reinstall the wheels after removing
the pivot shafts.
Fig. 0477 DSCN-0717a
To Next Page
Loading...
