CONTROLS
4-5Toro GrandStand Service Manual
4
3. Remove the two screws securing the pivot shaft in-
side the RH motion control lever (Fig. 0644 & 0645).
Note: Only one bolt will typically back out due to
both threading into the same inner rod. A #4
easy-out can be used to secure the pivot rod.
The bolt on the opposite side can then be
removed (Fig. 0646).
Fig. 0644 IMG-0977a
Fig. 0645 IMG-0979a
Fig. 0646 IMG-0980a
4. Remove the RH control lever assembly from the
control tower (Fig. 0647).
Fig. 0647 IMG-0983a
To Next Page
Loading...
