Toro GrandStand Series - Page 196

CONTROLS
4-9Toro GrandStand Service Manual
4
7. Secure the control handle assembly in the control
tower using two bolts (Fig. 0660 & 0661).
8. Install the wire harness onto the OPC switch (Fig.
0662).
Fig. 0660 IMG-0977a
Fig. 0661 IMG-0979a
Fig. 0662 IMG-0976a
9. Position the RH control handle so it is horizontally
aligned with the LH lever (Fig. 0663).
Fig. 0663 IMG-058a