Toro GrandStand Series - Page 197

CONTROLS
4-10 Toro GrandStand Service Manual
4
10. Secure the position of the RH lever by tightening
the nut on the adjustment cam on the RH control
assembly (Fig. 0664).
12. Secure the position of the switch by tightening the
two mounting screws (Fig. 0666).
Fig. 0664 IMG-059a
11. Adjust the OPC switch so there is .125” (3mm) gap
between the switch plunger and the control handle
tab when the control handle is in the operating
position (Fig. 0665).
Fig. 0665 IMG-8389a
Fig. 0666 IMG-8390a
13. Secure the control cable to the motion control lever
using a bolt, nut and spacer (Fig. 0667).
A. .125” (3mm) gap
Fig. 0667 IMG-0974a
A