Toro GrandStand Series - Page 213

CONTROLS
4-26 Toro GrandStand Service Manual
4
6. 2009 Only: Serial range 290000001 - 290000209:
Slide 3 rollers onto the rear end of the LH shifter link
rod. Slide the rear end of the shifter link rod (with 3
rollers) into the control fork assembly (Fig. 0728).
8. 2009 Only: Serial range 290000210 - 290999999:
Using an Allen wrench, locate the center roller and
slide the Allen wrench through it (Fig. 0730).
Fig. 0728 IMG-9373a
7. 2009 Only: Serial range 290000210 - 290999999:
Push down on the control fork assembly and slide
the center roller into the slot of the pump control arm
(Fig. 0729).
Fig. 0729 IMG-9371a
Fig. 0730 IMG-9401a
9. 2009 Only: Serial range 290000210 - 290999999:
Slide the right hand roller onto the rear end of the
LH shifter link rod. Slide the rear end of the shifter
link rod (with roller) through the control fork assem-
bly following the Allen wrench through to capture the
center roller on the shifter link rod (Fig. 0731).
Fig. 0731 IMG-9367a