Toro GrandStand Series - Speed Control Cable & Shifter Replacement

CONTROLS
4-31Toro GrandStand Service Manual
4
Speed Control Cable & Shifter
Replacement
Speed Control Cable & Shifter Removal
2. Remove the cable clip and then the “Z” bend of the
cable from the speed control lever assembly (Fig.
0747).
1. Remove the speed control handle knob and then the
two screws and nuts securing the handle assembly
to the control tower (Fig. 0746).
Fig. 0746 IMG-0145a
Fig. 0747 IMG-0145a
4. 2009 Only: Remove the hairpin cotters and wash-
ers securing the RH & LH shifter links to the shifter
brackets (Fig. 0749).
3. Remove the two cable ties securing the speed
control cable to the RH control cable and the left
side of the linkage mount (Fig. 0748).
Fig. 0748 IMG-1089a
Fig. 0749 IMG-0348a