Toro GrandStand Series - Page 219

CONTROLS
4-32 Toro GrandStand Service Manual
4
5. 2010 Only: Remove the bolt, nut, washers, and
spacer securing the front end of the RH & LH shifter
links to the shifter bracket (Fig. 0750).
Fig. 0750 IMG-0346a
6. Using a spring tool, unhook the “J” end of the torsion
spring from the lower shifter bracket (Fig. 0751).
Fig. 0751 IMG-1121a
7. Remove the two screws securing the shifter bracket
assembly to the engine base (Fig. 0752).
Fig. 0752 IMG-0153a
8. Remove the shifter bracket assembly and speed
control cable from the chassis (Fig. 0753).
Fig. 0753 IMG-0159a