CONTROLS
4-51Toro GrandStand Service Manual
4
5. Remove the two screws and nuts securing the
throttle lever assembly to the control panel (Fig.
0821).
3. From the rear of the machine, pull the cable rear-
ward from the frame.
4. Remove the throttle knob from the throttle lever (Fig.
0820).
Fig. 0820 IMG-1156a
Fig. 0821 IMG-1158a
6. Remove the cable clip and then the “Z” bend of the
cable from the throttle control lever assembly (Fig.
0822).
Fig. 0822 IMG-1160a
To Next Page
Loading...
