ENGINE
5-10 Toro GrandStand Service Manual
5
5. Install the square key in the crankshaft and apply
anti-seize around the crankshaft (Fig. 0871).
8. Apply thread locking compound to clutch bolt
threads (Fig. 0873).
Fig. 0871 IMG-0545a
6. Lower the engine into the chassis until the base of
the engine is approximately 1-1/2” (3.81cm) from the
engine base.
7. Install the engine drive pulley with the large hub
facing up toward the engine (Fig. 0872).
Fig. 0872 IMG-0557a
Fig. 0873 IMG-0563a
9. Install the electric clutch onto the engine crankshaft
and loosely install the clutch bolt, spring washer and
washer (Fig. 0874).
Note: On 2010 models, make sure the PTO bracket
stop ts into the slot on the clutch.
Fig. 0874 IMG-0558a
To Next Page
Loading...
