Toro GrandStand Series - Page 252

ENGINE
5-11Toro GrandStand Service Manual
5
10. Install the 4 screws and Belleville washers securing
the engine to the engine base. Torque the screws to
30 ± 4 ft-lbs. (41 ± 5 Nm) (Fig. 0875).
12. Torque the clutch bolt to 55 ± 5 ft-lbs. (75 ± 7 Nm)
(Fig. 0877).
Fig. 0875 IMG-0511a
11. Remove one spark plug and feed a minimum of 2
feet (61cm) of 3/8” (.95cm) rope into the cylinder to
prevent engine rotation (Fig. 0876).
Note: Rotate crankshaft as needed to permit feeding
the rope into the cylinder.
Fig. 0876 IMG-9634a
Fig. 0877 IMG-0566a
13. Remove the rope from the engine cylinder and install
spark plug.
14. 2009 ONLY: Install the bolt, washers, spacer and nut
securing the clutch brake strap to the mower deck
(Fig. 0878).
Fig. 0878 IMG-9624a
A. Bolt D. Spacer
B. Washers (2) E. Washer
C. Clutch strap F. Nut
A
B B
D
C
E
F