ENGINE
5-12 Toro GrandStand Service Manual
5
15. Feed the clutch wire through the hole in the engine
base and install the rubber grommet (Fig. 0879).
16. Install the pump drive belt around the engine drive
pulley, the two hydraulic pump pulleys and the idler
pulley (Fig. 0880).
17. Install the extension spring from the idler bracket to
the spring anchor bracket (Fig. 0881).
Note: On 2009 machines the extension spring
hooks to the back of the engine base.
Fig. 0879 IMG-0567a
Fig. 0880 IMG-0568a
Fig. 0881 IMG-0496a
18. Install the 3 carriage bolts and 3 nuts securing the
skid plate to the mower deck (Fig. 0882).
Fig. 0882 IMG-0503a
To Next Page
Loading...
