Toro GrandStand Series - Page 345

HYDRAULIC DRIVE SYSTEM
6-86 Toro GrandStand Service Manual
6
12. Remove the ttings from the lter mount (Fig. 1216).
Fig. 1216 IMG-0867a
Hydraulic Filter Mount Installation
1. Install new o-rings onto the ttings (Fig. 1218).
13. Remove the o-rings from the ttings (Fig. 1217).
Fig. 1217 IMG-0866a
Fig. 1218 IMG-0869a
2. Install a tting into the lter mount “OUT” port (Fig.
1219).
Fig. 1219 IMG-0871a