Toro GrandStand Series - Page 346

HYDRAULIC DRIVE SYSTEM
6-87Toro GrandStand Service Manual
6
3. Orient the tting so it is pointing rearward, to wards
the lter mounting face. Secure the position with the
tting jam nut (Fig. 1220).
5. Orient the tting so it is pointing forward, away from
the lter mounting face. Secure the position with the
tting jam nut (Fig. 1222).
Fig. 1220 IMG-0875a
4. Install a tting onto the lter mount “IN” port (Fig.
1221).
Fig. 1221 IMG-0877a
Fig. 1222 IMG-0877a
6. Position the lter mount so the “FLOW” arrow is
pointing up (Fig. 1223).
Fig. 1223 IMG-0878a