Toro GrandStand Series - Page 357

MOWER DECK
7-2 Toro GrandStand Service Manual
7
3. Verify the idler pulley spring is stretched to 5-3/4”
(14.6 cm) from hook to hook (Fig. 1248).
4. If the idler pulley spring requires adjustment, loosen
the front idler pulley by loosening the nut (Fig. 1248).
5. Using a ratchet in the front idler arm, tighten the idler
pulley until the spring is stretched to 5-3/4” (14.6 cm)
from hook to hook (Fig. 1248).
6. Secure the front idler arm by tightening the nut (Fig.
1248).
7. Install the RH and LH mower belt covers (Fig. 1249).
Fig. 1248 g. 61 G009460
Fig. 1249 IMG-0485a
A. 5-3/4” (14.6cm) from D. Ratchet
hook to hook E. Square hole for ratchet
B. Spring F. Nut
C. Spring loaded idler
A
B
D E F
C