Toro GrandStand Series - Solenoid Installation

ELECTRICAL
8-34 Toro GrandStand Service Manual
8
Solenoid Installation
5. Remove the two thread forming screws securing the
solenoid the engine base plate (Fig. 1533).
1. Secure the solenoid to the engine base using two
thread forming screws (Fig. 1534).
Fig. 1533 IMG-1297a
Fig. 1534 IMG-1297a
2. Install the blue and green wires to the two small
studs on the solenoid using the wire’s bullet con-
nectors (Fig. 1535).
Fig. 1535 IMG-1295a