Toro GrandStand Series - Operator Presence Control (OPC) Switch Removal; Operator Presence Control (OPC) Switch Installation

ELECTRICAL
8-36 Toro GrandStand Service Manual
8
Operator Presence Control (OPC) Switch
Removal
Operator Presence Control (OPC) Switch
Installation
1. Remove the wire harness from the switch (Fig.
1540).
1. Loosely install the two screws and threaded
plate that secure the switch to the control handle
assembly (Fig. 1542).
Fig. 1540 IMG-1262a
2. Remove the two screws and threaded plate that
secure the switch to the control handle assembly
and remove the switch (Fig. 1541).
Fig. 1541 IMG-1264a
Fig. 1542 IMG-1264a
2. Move the RH control lever to the operating position
(Fig. 1543).
Fig. 1543 IMG-058a