ELECTRICAL
8-37Toro GrandStand Service Manual
8
3. Position the switch so there is an 1/8” (3mm) gap
between the switch plunger and the tab on the
handle assembly (Fig. 1544).
5. Plug the wire harness into the switch (Fig. 1546).
Fig. 1544 IMG-1267a
4. Secure the position of the switch by tightening the
two mounting screws (Fig. 1545).
Fig. 1545 IMG-1264a
Fig. 1546 IMG-1262a
To Next Page
Loading...
