Toro GrandStand Series - Neutral Switch Removal; Neutral Switch Installation

ELECTRICAL
8-38 Toro GrandStand Service Manual
8
Neutral Switch Removal Neutral Switch Installation
A. Screw (2) C. 1/8” (3mm) gap
B. Switch
1. Remove the wire harness from the switch (Fig.
1547).
1. Loosely install the two screws and threaded plate
that secure the switch to the control handle assem-
bly (Fig. 1549).
2. With the controls in the neutral position, position the
switch so there is an 1/8” (3mm) gap between the
switch plunger and the tab on the neutral plate (Fig.
1549).
3. Secure the position of the switch by tightening the
two mounting screws (Fig. 1549).
Fig. 1547 IMG-1272a
2. Remove the two screws and threaded plate that
secure the switch to the neutral plate and remove
the switch (Fig. 1548).
Fig. 1548 IMG-1276a
Fig. 1549 IMG-1276a
4. Plug the wire harness into the switch (Fig. 1550).
Fig. 1550 IMG-1272a
A
B
C