Toro GrandStand Series - Page 63

CHASSIS
3-42 Toro GrandStand Service Manual
3
11. Repeat step 10 on the other side if replacing both
gas spring assemblies.
12. Loosen the lower nut on the lift bar approximately 2
turns until the Height-Of-Cut handle can be moved
from the transport position (Fig. 0155).
14. Remove the retaining clip from the rear end of the
gas spring assembly (Fig. 0157).
Fig. 0155 IMG-9749a
13. Lower the Height-Of-Cut handle to the 1” (2.54cm)
height-of-cut setting (Fig. 0156).
Fig. 0156 IMG-9738a
Fig. 0157 IMG-9711a
15. Remove the gas spring assembly (Fig. 0158).
Fig. 0158 IMG-9714a
16. Repeat steps 14 and 15 on the other side if replac-
ing both gas spring assemblies.