Toro GrandStand Series - Page 73

CHASSIS
3-52 Toro GrandStand Service Manual
3
14. Remove both sets of hydraulic ttings from the
wheel motor (Fig. 0192).
16. Remove the four bolts and washers securing the
wheel motor to the wheel motor housing (Fig. 0194).
Fig. 0192 DSCN-0670a
15. Cap the wheel motor ports and hydraulic hoses to
prevent debris from entering the system (Fig. 0193).
Fig. 0193 DSCN-0639a
Fig. 0194 DSCN-0647a
17. Remove the wheel motor from the wheel motor
housing.
18. Repeat steps 6 through 17 on the other side of the
machine.
19. Support the motor mount/axle assembly with a oor
jack (Fig. 0195).
Fig. 0195 DSCN-0649a