Toro GrandStand Series - Page 75

CHASSIS
3-54 Toro GrandStand Service Manual
3
2. Position the motor mount/axle assembly under the
carrier frame (Fig. 0200).
4. Tighten the four sets of fasteners.
5. Position the wheel motor into the wheel motor
housing (Fig. 0202).
Fig. 0200 DSCN-0649a
3. Loosely install the four sets of bolts (2 per side),
spacers, and nuts that secure the motor mount/axle
assembly to the carrier frame (Fig. 0201).
Fig. 0201 DSCN-0652a
Fig. 0202 DSCN-0664a
6. Secure the wheel motor to the wheel motor housing
using four bolts and Belleville washers. Torque the
bolts to 75 ± 8 ft-lbs. (102 ± 10 Nm) (Fig. 0203).
Note: Install the Bellville washers with the crown
facing the bolt head.
Fig. 0203 DSCN-0668a