Toro GrandStand Series - Page 76

CHASSIS
3-55Toro GrandStand Service Manual
3
7. Replace the tting o-rings. Install the two motor
ttings so they point towards the machine. Secure
the position of the ttings with the tting jam nut (Fig.
0204).
9. Repeat steps 5 through 8 on the other side of the
machine.
10. Position the woodruff key in the wheel motor shaft
(Fig. 0206).
Fig. 0204 DSCN-0670a
8. Install the hydraulic hoses to the hydraulic ttings
(Fig. 0205).
Fig. 0205 DSCN-0673a
Fig. 0206 DSCN-0675a
11. Position the wheel hub onto the motor shaft (Fig.
0207).
Fig. 0207 DSCN-0676a