Toro GrandStand User Manual

FormNo.3361-684RevA
GrandStand
™
Mowers
AllGrandStand
™
Mowers
Addendum
Ensurethetractionrollersarelubricatedatthenew
interval.KeepthisaddendumwithyourOperator’s
Manual.
LubricatingtheMachine
ServiceInterval:Every200hours/Yearly(whichever
comesrst)—Lubricatethetraction
rollers(moreoftenindirtyordusty
conditions).
Lubricatethetractionrollerswithadrylubricant
(PTFE).
Figure1
AdjustingtheSpeedControl
Lever
1.DisengagethePTO,movetherightsidemotion
controllevertotheneutralpositionandsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.MovetheHOClevertothe1inchheight-of-cut
position(lowestposition)(Figure2).
4.Movethespeedcontrollevertothefastposition
(Figure2).
5.Holdthemotioncontrolleversfullyforward.
Figure2
1.Motioncontrolleversfully
forward
3.HOCleverinthe1inch
height-of-cutposition
(lowestposition)
2.Speedcontrolleverinfast
position
6.Locatethecableandcableclampundertheframein
frontoftheleftwheel,asshown(Figure3).
7.Loosenthecableclampandpullthecabletowards
rearoftheunituntiltight(Figure3).
8.Tightenthecableclampbutnotsotightthatit
restrictsthetravelofthecable(Figure3).
Figure3
1.Clamp2.Cable
©2008—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
Registeratwww.Toro.com.
OriginalInstructions(EN)
PrintedintheUSA.
AllRightsReserved

Toro GrandStand Specifications

General

Drive System	Hydrostatic
Engine Type	4-Cycle
Cutting Width	52 inches
Deck Material	Steel
Warranty	3 years

Summary

Lubricating the Machine

Service Interval and Lubrication

Lubricate traction rollers every 200 hours/yearly using a dry lubricant (PTFE).

Adjusting the Speed Control Lever

Preparation for Adjustment

Disengage PTO, set motion control to neutral, engage parking brake, and stop the engine.

Setting Control Levers

Position HOC lever to 1 inch height and speed control lever to fast position.

Cable Adjustment Steps

Locate cable clamp, loosen, pull cable tight, and retighten clamp without restricting travel.