Toro GROUNDSMASTER 3000-D - Tire Pressure Check; Wheel Nut Torque Check

14
BEFORE OPERATING
Figure 8
1. Check Plug
2. Drain Plug
1
2
CHECK TIRE PRESSURE (Fig. 9)
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure. Correct
air pressure in the front and rear tires is 15 psi.
Figure 9
1. Rear Tire
1
IMPORTANT: Maintain even pressure in all tires to
assure a good quality-of-cut and proper machine
performance. DO NOT UNDER INFLATE.
CHECK TORQUE OF WHEEL NUTS
WARNING
Torque wheel nuts to 7580 ft-lb after 14
hours of operation and again after 10
hours of operation and every 200 hours
thereafter. Failure to maintain proper
torque could result in failure or loss of
wheel and may result in personal injury.