EasyManua.ls Logo

Toro GROUNDSMASTER 3000-D - Page 21

Toro GROUNDSMASTER 3000-D
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
MAINTENANCE SCHEDULE
Minimum Recommended Maintenance Intervals
Lubricate All Grease Fittings
Inspect Air Filter
Check Battery Level/Cable Connections
Change Engine Oil and Filter
Inspect Cooling System Hoses
Check Fan and Alternator Belt Tension
Torque Wheel Lug Nuts
Service Spark Arrester Muffler
Service Air Filter
Change Fuel Filter
Inspect Fuel Lines and Connections
Check Engine RPM (idle and full throttle)
Check Rear Axle Oil Level (4wd)
Change Hydraulic Oil
Change Hydraulic Oil Filter
Change Rear Axle Oil Level (4wd)
Inspect Engine Timing Belt (see note below)
Drain and Clean Fuel Tank
Pack 2WD Rear Axle Bearings
Check Rear Wheel Toe-In
Initial break in at 10 hours
Initial break in at 50 hours
Initial break in at 200 hours
Replace Moving Hoses
Replace Safety Switches
Cooling System Flush/Replace Fluid
Maintenance Procedure
Every
50hrs
Every
100hrs
Every
200hrs
Every
800hrs
Maintenance Interval & Service
Annual Recommendations:
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
Every
400hrs
NOTE: Replace Timing Belt after every 2500 hours of operation or if worn, cracked, oil soaked or
any time the Belt is removed or loosened.

Related product manuals