How to fix wrong and flashing current time on Toro Lawn Master II 53806 Timer?
If the current time on your Toro Timer is wrong and flashing after a power outage or unplugging, the battery is likely weak or missing. Replace the battery and reprogram the timer to resolve this issue.
What to do if manual station and program operations do not activate on Toro Lawn Master II 53806?
If Manual Station and Program Operations do not activate on your Toro Timer, it might be because the Function Dial was rotated too quickly to the RUN position. Rotate the function dial slowly to the RUN position.
Why no valves operate on my Toro Lawn Master II 53806?
If no valves are operating on your Toro Timer, several issues could be the cause. First, ensure the function dial is set to the RUN or MANUAL position, not OFF. Then, verify that the START TIMES, WATERING DAYS, and SET ZONE TIMES are correctly programmed and not set to off. Also, check that the SEASON ADJUST is not set to 0%. Finally, confirm that the AC power source is properly connected; check and reconnect the plug-in transformer, especially if 'NO AC' is displayed.
What to do if some valves do not operate on my Toro Lawn Master II 53806 Timer?
If some valves are not operating on your Toro Timer, it could be due to a defective solenoid. Test and replace the solenoid to resolve this. Another possible cause is a loose wire connection. Secure all wire connections and check for wire continuity.
Why won’t valves turn off on my Toro Lawn Master II 53806 Timer?
If the valves on your Toro Timer won’t turn off, even with the function dial switch in the OFF position, the mechanical override might be engaged. Turn the valve’s solenoid fully clockwise to disengage the manual bleed and allow the valve to close properly.
Setting TIME/DAY, WATERING DAYS, and START TIMES.
Defining station runtimes and seasonal adjustments.
Verify watering schedules after power interruptions.
Steps to connect the transformer to the controller and outlet.
Connecting sensor wires and ensuring correct circuit type.
Splice common wire to solenoid leads and COM terminal.
Connect Master Valve and station wires to their terminals.
Adjusting current YEAR, MONTH, DAY, AM/PM, HOUR, and MINUTE.
Selecting specific weekdays for watering.
Setting watering for ODD or EVEN numbered days.
To Next Page
General
