Toro Power Clear 418 - Page 57

POWER PROPEL SYSTEM
4-9
Toro Single Stage Snow Service Manual
5. Remove the bearing spacer bolt and bearing spacer.
6.  Removebearingsandanges.Replacerotorparts
as required (Fig. 019).
7. Re-install the bearing spacer and bolt. Torque bolt to
20 ft-lbs (27 Nm) (Fig. 020).
8. Re-install the rotor assembly into the housing.
Re-install the rotor bearing screws. Torque to
8 ft-lbs (11 Nm) (Fig. 021).
9. Re-install the drive belt and rotor pulley. Torque the
rotor pulley bolt to 8 ft-lbs (11 Nm) (Fig. 022).
10. Re-install the belt cover. Torque the bolts to 8 ft-lbs
(11 Nm).
Fig. 019
Fig. 021
Fig. 020
Power Propel System
4
Fig. 022