Toro Power Clear 518ZR - Preparing the Snowthrower for First Use; Installing the Handle; Installing the Discharge Chute

117-7713
1.Warning—readtheOperator’sStartGuideandtheOperator's
Manual.
4.Fuelspillhazard—donottipmachineforwardorbackward.
2.Cutting/dismembermenthazard,impeller—stoptheengine
beforeleavingthemachine.
5.Toengagetheauger,squeezethecontrolbar.
3.Thrownobjecthazard—keepbystandersasafedistancefrom
themachine.
6.Releasethecontrolbartodisengagetheauger.
PreparingtheMachine
forFirstUse
InstallingtheHandle
1.Positiontheendsoftheupperhandleontheinsideof
thelowerhandleandaligntheholes.
2.Inserttheoval-headboltsintothealignedholes,with
theboltheadsontheoutsideofthehandle(Figure4).
Figure4
1.Oval-headbolt(2)2.Curvedwashersand
handleknobs
3.Installthecurvedwashersandthehandleknobsonthe
oval-headboltsontheinsideofthehandle(Figure4)
andtightentheknobssecurely.
Important:Ensurethatthecableisroutedtothe
outsideofthehandle.
InstallingtheDischargeChute
InstallthedischargechuteasshowninFigure5.
Figure5
1.Knob
2.Bolt(2),washer(2),and
locknut(2)
Note:Installtheboltsfromtheinsideofdischargechuteso
thatthewashersandlocknutsareontheoutsideofthechute.
Important:Donotovertightenthelocknuts.
3