Toro Power Sweep 51586 - Installation; Install Blower Tube; Remove Blower Tube; Securing Power Supply Cord

EN–4
Installation
Install Blower T ube
1. Slide tube onto blower outlet until tabs on tube
snap into latch (Fig. 3).
Remove Blower T ube
1. Depress tabs on top and bottom of tube to
release tabs from latch (Fig. 3). Slide tube off
blower outlet.
Before Starting
Securing Power Supply Cord
Use only a UL listed (CSA certified in Canada)
extension cord recommended for outdoor use. Refer
to Extension Cord Chart.
EXTENSION CORD CHART
If length of extension cord is
less than or equal to:
100 ft. 150 ft.
Assure wire size gauge
(A.W .G.) in cord is:
16 14
Note: Use of an extension cord over 150 feet
is not recommended.
POTENTIAL HAZARD
• Contact with water while operating unit
could cause electric shock.
WHAT CAN HAPPEN
• Electric shock can cause injury or death.
HOW TO AV
OID THE HAZARD
• Don’t handle plug or appliance with wet
hands or while standing in water.
• Use only a UL listed (CSA certified in
Canada) extension cord recommended for
outdoor cold weather use. Refer to
Extension Cord Chart, page 4.
To reduce the risk of electric shock, this appliance has
a polarized plug (one blade is wider than the other)
(Fig. 4). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, consult a
qualified electrician to install the proper outlet. Do
not change the plug in any way.
1. Form a loop in extension cord and insert it
through slot in rear of blower housing (Fig. 5).
2. Secure extension cord in cord lock (Fig. 5 & 6).
POTENTIAL HAZARD
• The extension cord may not be fully seated
on inlet plug.
WHAT CAN HAPPEN
• A loosely connected extension cord could
lead to overheating and cause a fire.
HOW TO AV
OID THE HAZARD
• Make sur e the extension cord is fully seated
on inlet plug and ALWA
YS USE THE
CORD LOCK FEATURE to ensure that
cord r emains secur ed during operation
(Fig. 5 & 6).
Note: Do not unplug extension cord by
pulling on cord. To unplug, grasp the
plug, not the cord.
POTENTIAL HAZARD
• The electrical cord could be damaged.
WHAT CAN HAPPEN
• A damaged electrical cord could cause a
shock or fire.
HOW TO AV
OID THE HAZARD
• Thoroughly inspect electrical cord before
using unit. If cord is damaged, do not
operate unit. Replace or repair damaged
cord immediately. Contact your TORO
service dealer for assistance.