Toro ProLine H800 - Installing the Rear Bumper

g315988
Figure6
Hookinstalled
1.Rightside
2.Leftside
4
InstallingtheRearBumper
Partsneededforthisprocedure:
1Rearbumper
4Bolt
8Flatwasher
4Locknut
4
Cableties
Procedure
1.Removethehardwarefromtherearbumper
(Figure7).
2.Installtherearbumperunderthehopperwith
thepreviouslyremovedhardware(Figure7).
3.Connectthewireharnesstothemachine
harness.
4.Verifythattheleftandrightturnlightsare
hookedupcorrectlybyusingtheturnsignal.If
needed,changetheconnections.
5.Usethecabletiestofastenthewireharnessto
therearbumper.
g316095
Figure7
1.Rearbumper3.Washer
2.Bolt4.Locknut
5