Assembling the Lower Brush
Brackets to the Machine
1. Align the holes in the lower brush bracket with
the holes in the groomer brush support of the
mower deck as shown in Figure 8 .
g284634
Figure 8
1. Lower brush bracket
3. Support (groomer
brush—mower deck)
2. Self-tapping, ange-head
screw (6 x 20 mm)
2. Secure the lower brush bracket to the groomer
brush support ( Figure 8 ) with 2 self-tapping,
ange-head screws (6 x 20 mm).
3. Repeat steps 1 and 2 for the other lower brush
bracket at the other side of the machine.
4. Carefully lower the machine ( Figure 9 ).
g284636
Figure 9
Assembling the Groomer Brush to
the Lower Brush Brackets
1. Assemble a capscrew (6 x 20 mm) and washer
(6 mm) through the hole in the brush mount
( Figure 10 ).
g284658
Figure 10
1. Capscrew (6 x 20 mm) 3. Hole (brush mount)
2. W asher (6 mm)
2. Assemble the other capscrew (6 x 20 mm) and
washer (6 mm) through the other hole in the
brush mount ( Figure 10 ).
3. Align the capscrews that you assembled in steps
1 and 2 through the holes of the lower brush
brackets as shown in Figure 1 1 .
g284657
Figure 1 1
1. Capscrew (6 x 20 mm) 3. W asher (6 mm)
2. Lower brush bracket
4. Locknut (6 mm)
4. Assemble the brush mount and capscrews to
the lower brush brackets ( Figure 1 1 ) with 2
washers (6 mm) and 2 locknuts (6 mm).
6