Figure12
1.Pivotpoint2.Pivotpointwhenthe
parkingbrakeisengaged.
3.Movethemachinetothefrontofthestumpandset
theparkingbrake.
4.MovethrottleuptotheEngageposition.Thecutting
wheelwillbeginrotating.
5.Swingthecuttingwheeltooneside(Figure12),then
loweritapproximately13mmto25mm(1/2inchto
1inch)intothefront-topcornerofthestump.Swing
thecuttingwheelbackandforth,loweringthecutting
wheelapproximately13mmto25mm(1/2inchto1
inch)beforeeachsweep,untilyouhaveremovedthe
frontportionofthestumptogroundlevel(Athrough
DinFigure13).
Figure13
6.Raisethecuttingwheel,releasetheparkingbrake,
andmovethemachineforwardafewinches.Setthe
parkingbrake.
7.Repeatsteps5and6untilyouhavecompletely
removedthestump(EthroughHinFigure13).
8.MovethrottletotheDisengageposition,pushthe
handledownenoughtoraisethecuttingwheeloffthe
ground.Waitforthecuttingwheeltostoprotating
thenreleasetheparkingbrakeandpullthemachine
awayfromthestump.
Note:Donotletthefrontofthemachinetouchthe
grounduntilyouaresurethecuttingwheelhasstopped
turning.
9.Stopthemachine;refertoStoppingtheEngine(page
10).
11