Revision 1 02-24-2021 Toro Form No 3445-719 Rev A
Maintenance Service Interval Maintenance Procedure
Clean the air filter cyclone housing, air channels, and air intake screen.
Every 100 hours • Change the engine oil.
• Clean the fuel sediment cup.
• Check the spark plugs.
• Replace the drive belt.
Every 200 hours Replace the air filter.
• Clean the sediment cup.
Important: Refer to the Engine Operator's Manual for additional maintenance procedures.
Tool Cleaning Process
Regular cleaning and washing will increase the life span of the machine. Clean the machine after use, before the dirt hardens.
Check before cleaning that the fuel tank cap is properly in place to avoid getting water in the tank.
Use care when using a high-pressure washer because it can damage decals, grease seals, and the engine.
Important: Lubricate the cutting wheel blade bearings after cleaning.
To Next Page
Loading...
Need help?
General
