Toro Snow Commander 38602 - Handle and Chute Assembly

1. Unfolding the Handle
1. Cut the plastic tie that secures the control cable to the
handle .
2. Loosen the knobs and pull out the handle bolts ( Figure
3 ).
Figure 3
3. R otate the upper handle to the operating position
( Figure 4 ).
Figure 4
4. Install the handle bolts , set the cable guide in position,
and tighten the knobs until they are sn ug ( Figure 5 ).
Figure 5
5. Adjust the rotor control cable and the traction dri v e
cable . R efer to Adjusting the R otor Control Cable and
to Adjusting the T raction Dri v e Cable .
2. Installing the Discharge
Chute
Install the disc harg e c hute as sho wn ( Figure 6 ).
Figure 6
6