Toro TIMECUTTER HD 75202 - Hydrostatic Drive Belt Removal (Cont.)

7-10
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Hydrostatic Drive Belt (Cont.)
Removal (Cont.)
6. Remove the rear pulley (A) (Figure 8).
7. Remove the idler arm and pulley (B) (Figure 8).
8. Remove the drive belt from the hydrostatic drive pulleys.
NOTE: Inspect the belt for excessive wear, damage, or cracking, replace if necessary.
Figure 8
A
B