7-12
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Hydrostatic Drive Belt (Cont.)
Installation (Cont.)
4. Place the idler spring onto the idler arm loop and use a spring removal tool to secure the spring (A) into the slot
on the right rear of the frame (Figure 10).
NOTE: Ensure proper orientation with hook openings facing away from the idler pivot.
5. Install the mower belt onto the clutch, see “Mower Belt Replacement,” chapter 3, page 3-15.
6. Lower the unit.
7. Connect the battery and check for proper operation.
Figure 10
A
To Next Page
Loading...
