Toro TIMECUTTER HD 75202 - Choke Control Assembly Installation (Cont.)

5-28
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Choke Control Assembly (Cont.)
Installation (Cont.)
6. Place the z bend of the choke cable in the choke plate on the engine in the position previously noted.
7. Place the cable under the cable clamp.
8. Ensure that the choke control lever is pressed down fully and tighten the cable clamp (Figure 35).
9. Connect the battery terminals and verify proper function of the unit.
Figure 35