Toro TimeCutter SW5050 - Page 74

HYDROSTATIC DRIVE SYSTEM
5-9
Toro Timecutter SW/SWX Service Manual
5
8. Remove the drive belt tensioner spring (Fig. 063).
Fig. 063 PICT-1091
9. Slip the drive belt off the idler pulleys, then off the
appropriate hydro input pulley.
10. If equipped, disconnect and plug the hydro reservoir
hoses at the hydro tting. Be sure to capture and
dispose of uid and shop towels properly (Fig. 064).
(SWX only)
Fig. 064 PICT-1104
11. Remove the hydro center support:
Wide Frame – Remove the (6) mounting fasteners (Fig.
065).
Fig. 065 PICT-1094
Narrow Frame – Remove the (4) mounting fasteners
(Fig. 066).
Fig. 066 PICT-1095
12. Safely support hydro assembly in current position
using a hydraulic oor jack.