EasyManua.ls Logo

Toro Titan MR 4800 - User Manual

Toro Titan MR 4800
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3442-155RevA
Titan
®
MR4800orMR5400
RidingMower
ModelNo.75314—SerialNo.400000000andUp
ModelNo.75315—SerialNo.400000000andUp
Registeratwww.Toro.com.
OriginalInstructions(EN)
*3442-155*

Table of Contents

Questions and Answers

  • J
    Jesus McdowellAug 12, 2025
    Why Toro Lawn Mower engine does not start, starts hard, or fails to keep running?
    • T
      thompsonandrewAug 12, 2025
      Several factors can cause this issue: * The fuel tank might be empty, so fill the fuel tank. * The choke (if applicable) might not be on, so move the choke lever to the ON position. * The air cleaner could be dirty, so clean or replace the air-cleaner element. * The spark-plug wire(s) might be loose or disconnected, so install the wire(s) on the spark plug. * The spark plug(s) might be pitted, fouled, or the gap is incorrect, so install a new, correctly gapped spark plug(s). * There might be dirt in the fuel filter, so replace the fuel filter. * There might be incorrect fuel in the fuel tank, so drain the tank and replace the fuel with the proper type. * The oil level in the crankcase might be low, so add oil to the crankcase.
  • K
    Kaitlyn MuellerAug 16, 2025
    Why Toro Titan MR 4800 engine loses power?
    • C
      coxbobbyAug 16, 2025
      Your Toro Lawn Mower engine might be losing power due to several reasons: * The engine load is excessive; reduce the ground speed. * The air cleaner is dirty; clean the air-cleaner element. * The oil level in the crankcase is low; add oil to the crankcase. * The cooling fins and air passages under the engine blower housing are plugged; remove the obstruction from the cooling fins and air passages. * The spark plug(s) is pitted, fouled, or the gap is incorrect; install a new, correctly gapped spark plug(s). * There is dirt in the fuel filter; replace the fuel filter.
  • S
    Scott ColemanAug 20, 2025
    How to fix uneven cutting height on Toro Lawn Mower?
    • R
      Richard SmithAug 20, 2025
      To address an uneven cutting height on your Toro Lawn Mower: * Sharpen the blade(s) if they are not sharp. * Install a new cutting blade(s) if a cutting blade(s) is/are bent. * Level the mower from side-to-side and front-to-rear if the mower is not level. * Adjust the anti-scalp wheel height if an anti-scalp roller (if applicable) is not set correctly. * Clean the underside of the mower deck if it is dirty. * Adjust the tire pressure if it is incorrect.
  • A
    Ashley HendersonAug 23, 2025
    What to do if Toro Titan MR 4800 Lawn Mower blades do not rotate?
    • J
      jacobsteresaAug 23, 2025
      If the blades on your Toro Lawn Mower do not rotate: * Install a new drive belt if the drive belt is worn, loose or broken. * Install the drive belt and check the adjusting shafts and belt guides for the correct position if the drive belt is off of the pulley. * Install a new mower belt if the mower belt is worn, loose, or broken.
  • R
    Rachel GillAug 27, 2025
    What to do if my Toro Lawn Mower engine overheats?
    • S
      shelbymendozaAug 27, 2025
      If your Toro Lawn Mower engine overheats, consider the following: 1. The engine load might be excessive, so reduce the ground speed. 2. The oil level in the crankcase might be low, so add oil to the crankcase. 3. The cooling fins and air passages under the engine-blower housing might be plugged, so remove the obstruction from the cooling fins and air passages. 4. The air cleaner might be dirty, so clean or replace the air-cleaner element.
  • M
    Melissa JonesAug 31, 2025
    What to do if my Toro Titan MR 4800 starter does not crank?
    • T
      Timothy HallAug 31, 2025
      If the starter on your Toro Lawn Mower doesn't crank, check these items: * The blade-control switch may be engaged; disengage the blade-control switch. * The motion-control levers may not be in the NEUTRAL-LOCK position; move the motion-control levers outward to the NEUTRAL-LOCK position. * The battery may be dead; charge the battery. * The electrical connections may be corroded or loose; check the electrical connections for good contact. * A fuse may be blown; replace the fuse.
  • K
    kara04Sep 4, 2025
    Why does my Toro Lawn Mower vibrate abnormally?
    • J
      Jeffrey GonzalezSep 4, 2025
      Abnormal vibrations in your Toro Lawn Mower can be caused by: * Bent or unbalanced cutting blade(s): Install new cutting blade(s). * Loose blade mounting bolt: Tighten the blade mounting bolt. * Loose engine mounting bolts: Tighten the engine mounting bolts. * Loose engine pulley, idler pulley, or blade pulley: Tighten the appropriate pulley.
  • S
    Stephen DeleonSep 7, 2025
    Why Toro Titan MR 4800 fuel tank is collapsing?
    • D
      david00Sep 7, 2025
      If the fuel tank is collapsing or the machine frequently shows signs of running out of fuel, it could be because the air-cleaner paper element is clogged. Clean the paper element.

Toro Titan MR 4800 Specifications

General IconGeneral
Engine Displacement708cc
Cutting Width48 inches
TransmissionHydrostatic
Ground Speed (Reverse)3 mph
Cutting Height1.5 - 4.5 inches
Mulching CapabilityYes
Bagging CapabilityOptional
Side Discharge CapabilityYes
Blade Tip Speed18, 000 fpm
Ground Speed (Forward)8.5 mph
SeatHigh-back with armrests
Tires (Front)13 x 6.5 inches
Tires (Rear)22 x 9.5 inches
Wheel SizeFront: 13 in, Rear: 22 in
Warranty3 years

Related product manuals