Operator Platform (continued)
• When loading or unloading the machine from a trailer for transport
• Driving up slopes
Operate the machine with the platform down for the following conditions:
• Using the machine in most areas
• Driving across slopes
• Driving down slopes
Raising the Platform
1. Pull the platform up so that the latch pin and knob lock it into place.
2. Push it tight against the cushion for the latch pin to lock in place.
Lowering the Platform
G384424
1. Push the platform against the cushion to
release pressure on the latch pin.
2. Pull the latch pin knob out and lower the
platform.
Operating the Hopper
Hopper capacity: 1134 kg (2,500 lb)
Do not exceed the load capacity of the machine. This machine normally operates on
uneven, unpaved, bumpy, and/or inclined surfaces—adjust the load accordingly.
G375674
1. Position the machine where you intend to
dump the load.
2. Dump the hopper by pushing the top of the
dump switch
.
3. Lower the hopper by pushing the bottom of the
dump switch
.
Note: If you hold the bottom of the switch for 1 second, the hopper fully lowers
automatically.
3461-433A Page 4–7 Operation: During Operation
To Next Page
Loading...
