Toro Wheel Horse 13-32XLE User Manual (English)

Questions and Answers:

S
Scott JamesAug 1, 2025
Why won't my Toro Wheel Horse 13-32XLE Lawn Mower engine start?
- L
  loriharrisAug 1, 2025
  Several factors can prevent your Toro Lawn Mower engine from starting. It could be that you are not seated, the fuel tank is empty, or the air cleaner is dirty. Also, check if the spark plug wire is loose or disconnected, or if the spark plug is faulty. Other potential causes include a choke that is not closing, a dirty fuel filter, or an incorrect idle speed/mixture. In some cases, dirt, water, or stale fuel in the fuel system may be the reason.
H
harrelldanielAug 5, 2025
Why is my Toro Lawn Mower engine losing power?
- M
  Mr. Steven JohnsonAug 5, 2025
  Your Toro Lawn Mower engine might be losing power due to several reasons. An excessive engine load could be the cause; shift to a lower gear to reduce ground speed. Also, check if the air cleaner is dirty or if the oil level in the crankcase is low. Obstructions in the cooling fins and air passages under the engine blower housing can also lead to power loss. Other potential causes include a faulty spark plug, a plugged vent hole in the fuel cap, or a dirty fuel filter. In some cases, the issue might be related to dirt, water, or stale fuel in the fuel system.
D
dawn28Aug 10, 2025
Why is the cutting height uneven on my Toro Wheel Horse 13-32XLE Lawn Mower?
- T
  Taylor HolmesAug 10, 2025
  Uneven cutting height on your Toro Lawn Mower can be attributed to a few factors. Incorrect tire pressure can cause this, so set the tire pressure correctly. Also, the mower might not be level, so level it from side to side and from front to rear. Additionally, a dirty underside of the mower can interfere with the cutting height, so clean it.
J
Joseph WilliamsAug 14, 2025
What to do if the blade(s) does not rotate on my Toro Wheel Horse 13-32XLE Lawn Mower?
- P
  Pamela PadillaAug 14, 2025
  If the blade(s) on your Toro Lawn Mower does not rotate, it could be because the blade drive belt is worn, loose, or broken; install a new blade drive belt. Alternatively, the blade drive belt might be off of the pulley; install the blade drive belt and check the idler pulley and belt guides for the correct position.
K
Katherine FullerAug 18, 2025
What to do if Toro Wheel Horse 13-32XLE starter does not crank?
- P
  probertsAug 18, 2025
  If the starter on your Toro Lawn Mower doesn't crank, it could be due to several reasons: * The blade control (PTO) is engaged: Move the PTO to disengaged. * The parking brake is not on: Set the parking brake. * The battery is dead: Charge the battery. * The electrical connections are corroded or loose: Check the electrical connections for good contact. * A fuse is blown: Replace the fuse. If none of these steps resolve the issue, it may be due to a damaged relay or switch.
V
Vernon HuntAug 23, 2025
What causes my Toro Wheel Horse 13-32XLE engine to overheat?
- N
  Natalie JonesAug 23, 2025
  Your Toro Lawn Mower engine may overheat if the engine load is excessive; shift to a lower gear to reduce ground speed. Another reason could be a low oil level in the crankcase, so add oil. Also, check for obstructions in the cooling fins and air passages under the engine blower housing and remove them.
M
Megan WalkerAug 27, 2025
How to fix abnormal vibration in my Toro Wheel Horse 13-32XLE?
- R
  Rebecca HallAug 27, 2025
  Abnormal vibration in your Toro Lawn Mower can stem from several issues. The cutting blade(s) might be bent or unbalanced, in which case you should install new cutting blade(s). Another cause could be a loose blade mounting bolt or loose engine mounting bolts; tighten them accordingly. Also, check for a loose engine pulley, idler pulley, or blade pulley and tighten the appropriate pulley. If the engine pulley is damaged, it may also cause vibration.