Toro wheel horse 16-38 HXL User Manual (English)

Questions and Answers:

P
paul09Aug 12, 2025
What to do if my Toro wheel horse 16-38 HXL starter does not crank?
- A
  Anthony BushAug 13, 2025
  If the starter on your Toro Lawn Mower isn't cranking, there are several potential causes. First, ensure the blade control (PTO) is disengaged and the parking brake is set. Also, check if the battery is dead and needs charging. Corroded or loose electrical connections can also prevent the starter from cranking, so inspect them for good contact. Finally, a blown fuse could be the culprit, so try replacing it. If none of these steps work, a relay or switch may be defective, and you should contact an authorized service dealer.
F
francoseanAug 20, 2025
What to do if the blade(s) on my Toro Lawn Mower does not rotate?
- W
  Wesley SmithAug 20, 2025
  If the blade(s) on your Toro Lawn Mower isn't rotating, it could be due to a worn, loose, or broken blade drive belt, in which case you should install a new blade drive belt. Alternatively, the blade drive belt might be off the pulley; reinstall the blade drive belt and check the idler pulley and belt guides for correct positioning.
E
Ellen KlineAug 25, 2025
Why does my Toro wheel horse 16-38 HXL Lawn Mower engine lose power?
- E
  Eric BakerAug 25, 2025
  A loss of power in your Toro Lawn Mower engine can stem from several issues. If the engine load is excessive, reduce your ground speed. Check the air cleaner element and clean it if it's dirty. Ensure the oil level in the crankcase is adequate by adding oil if it's low. Remove any obstructions from the cooling fins and air passages under the engine blower housing. Replace the spark plug if it is pitted, fouled, or has an incorrect gap. Clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty. For issues related to dirt, water, or stale fuel in the fuel system, contact an authorized service dealer.
V
Veronica WhiteAug 28, 2025
Why is my Toro wheel horse 16-38 HXL cutting height uneven?
- M
  Melissa TaylorAug 28, 2025
  An uneven cutting height on your Toro Lawn Mower can be attributed to a few reasons. Check that the tire pressure is correct and adjust as needed. Ensure the mower is level from side-to-side and front-to-rear. Also, a dirty underside of the mower can interfere with cutting, so clean it thoroughly.
D
Douglas TylerAug 31, 2025
What to do if my Toro wheel horse 16-38 HXL engine overheats?
- C
  Cody KaneAug 31, 2025
  If your Toro Lawn Mower engine is overheating, there are a few things you can check. First, if the engine load is excessive, reduce your ground speed. Ensure the oil level in the crankcase is sufficient; add oil if it's low. Also, make sure the cooling fins and air passages under the engine blower housing are free from obstructions; remove any that you find.
A
Amanda HermanSep 4, 2025
Why is my Toro wheel horse 16-38 HXL experiencing abnormal vibration?
- C
  ctuckerSep 4, 2025
  Abnormal vibration in your Toro Lawn Mower can be caused by several factors: 1. A bent or unbalanced cutting blade(s). Install new cutting blade(s). 2. A loose blade mounting bolt. Tighten the blade mounting bolt. 3. Loose engine mounting bolts. Tighten the engine mounting bolts. 4. A loose engine pulley, idler pulley, or blade pulley. Tighten the appropriate pulley. If the engine pulley is damaged, contact an authorized service dealer.
J
jamiecaldwellSep 8, 2025
What to do if my Toro wheel horse 16-38 HXL machine does not drive?
- S
  Shaun AndersonSep 8, 2025
  If your Toro Lawn Mower isn't driving, first ensure the drive control is in the “OPERATE” position and not in the “PUSH” position. If that's not the issue, it could be due to a traction belt that is worn, loose, or broken, or a traction belt that is off the pulley. For these issues, contact an authorized service dealer.

Toro wheel horse 16-38 HXL Specifications

General

Transmission	Hydrostatic
Cutting Width	38 inches
Engine Power	16 HP
Turning Radius	18 inches
Deck Material	Steel
Cutting Height	1.5-4 inches (adjustable)
Speed	0 to 5.5 mph